06-30-2021, 07:48 PM
Hi,
I have been using two elegoo mars a bit for my work. I have been using mostly standard elegoo resin with about 50% print success rate. However I just started using peopoly tough resin and some liqcreate strong-x. I can't seem to get either of these resins to stick to build plate. I have tried changing setting in chitubox, put some wd-40 on the FEP, slightly roughed up the build plate and a lot of other stuff. Should I be going about things diffrently with these resins? Also how important is the smoothness of the FEP, mine is a bit scratched up but I would think that it would still print sometimes. I just ordered more FEP film.
My boss wanted me to play around with SLA a bit, so I haven't done that much research.
Thanks,
Will
I have been using two elegoo mars a bit for my work. I have been using mostly standard elegoo resin with about 50% print success rate. However I just started using peopoly tough resin and some liqcreate strong-x. I can't seem to get either of these resins to stick to build plate. I have tried changing setting in chitubox, put some wd-40 on the FEP, slightly roughed up the build plate and a lot of other stuff. Should I be going about things diffrently with these resins? Also how important is the smoothness of the FEP, mine is a bit scratched up but I would think that it would still print sometimes. I just ordered more FEP film.
My boss wanted me to play around with SLA a bit, so I haven't done that much research.
Thanks,
Will