Elegoo 3D Printers Forum › Troubleshooting › General Troubleshooting v
DIMENSION PROBLEMS- Help

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
DIMENSION PROBLEMS- Help
cliffyk Offline
Senior Member
****
Posts: 558
Threads: 15
Joined: Mar 2020
Reputation: 22
#13
02-22-2022, 01:04 PM (This post was last modified: 02-22-2022, 01:06 PM by cliffyk.)
There does not seem to be an attachment?

In what axis is the sphere 2 mm undersize? What exposure times are you using--my first thought is that there are too short?
-cliff knight-
[Image: 816-20120803-wide800.jpg]
paladinmicro.com
Find
Reply


Messages In This Thread
DIMENSION PROBLEMS- Help - by KenW - 02-07-2022, 10:56 AM
RE: DIMENSION PROBLEMS- Help - by cliffyk - 02-08-2022, 01:07 AM
RE: DIMENSION PROBLEMS- Help - by KenW - 02-08-2022, 11:22 AM
RE: DIMENSION PROBLEMS- Help - by cliffyk - 02-08-2022, 12:05 PM
RE: DIMENSION PROBLEMS- Help - by KenW - 02-08-2022, 12:18 PM
RE: DIMENSION PROBLEMS- Help - by cliffyk - 02-08-2022, 12:58 PM
RE: DIMENSION PROBLEMS- Help - by KenW - 02-08-2022, 01:12 PM
RE: DIMENSION PROBLEMS- Help - by cliffyk - 02-08-2022, 02:01 PM
RE: DIMENSION PROBLEMS- Help - by KenW - 02-08-2022, 03:41 PM
RE: DIMENSION PROBLEMS- Help - by cliffyk - 02-08-2022, 04:23 PM
RE: DIMENSION PROBLEMS- Help - by KenW - 02-08-2022, 04:46 PM
RE: DIMENSION PROBLEMS- Help - by KenW - 02-22-2022, 07:50 AM
RE: DIMENSION PROBLEMS- Help - by cliffyk - 02-22-2022, 01:04 PM
RE: DIMENSION PROBLEMS- Help - by KenW - 02-22-2022, 01:43 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)