08-18-2021, 04:58 AM
(This post was last modified: 08-18-2021, 05:09 AM by Penthesyle.)
For some time now I have been experiencing printing problems, nothing comes out correctly. I changed the tray, thinking that this was the problem. But nothing changes.
Either the figure comes off and stays in the tray or it comes out like on the picture. I don't understand where the problem comes from. I have an Elegoo mars for a long time and I use the grey resin
thank you in advance for your help
Either the figure comes off and stays in the tray or it comes out like on the picture. I don't understand where the problem comes from. I have an Elegoo mars for a long time and I use the grey resin
thank you in advance for your help