Elegoo 3D Printers Forum › Elegoo Saturn 4K / 8K 3D Printer › Getting Started v
Middle of UV Lamp doesn't turn on for prints

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Middle of UV Lamp doesn't turn on for prints
billtodd Offline
Member
***
Posts: 60
Threads: 3
Joined: Jul 2021
Reputation: 0
#5
10-13-2021, 10:13 AM
(10-13-2021, 03:02 AM)jasonthelamb Wrote: Talked with Elegoo support and figured it out... 100% my fault, was using the wrong power supply and the light board wasn't getting enough juice.
Oh well , I'm glad you've fixed it :-) Elegoo support is pretty good .
Find
Reply


Messages In This Thread
RE: Middle of UV Lamp doesn't turn on for prints - by billtodd - 10-13-2021, 10:13 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)