02-20-2022, 12:56 AM
99.44% of the time sticking to the FEP (bottom) really a failure to stick to the build plate (platen). This can often be resolved by very lightly soughing up the surface of the platen using fine sandpaper--320 or 400 grit.
If the finish on your platen is "mirror-like", as is typical with some of the Pro versions, roughing it up a bit will improve adhesion.
Also, in my experience water washable resin can be finicky, I do not recommend it for beginners...
If the finish on your platen is "mirror-like", as is typical with some of the Pro versions, roughing it up a bit will improve adhesion.
Also, in my experience water washable resin can be finicky, I do not recommend it for beginners...