Elegoo 3D Printers Forum › Troubleshooting › Prints Sticking to the FEP Film v
First layer sticks to FEP then nothing

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
First layer sticks to FEP then nothing
Christophe Offline
Junior Member
**
Posts: 5
Threads: 3
Joined: Aug 2023
Reputation: 0
#2
08-12-2023, 09:05 PM (This post was last modified: 08-13-2023, 10:40 AM by Christophe.)
Good morning,
Have you done Platform Leveling?
I'm having this problem on my Saturn 3 Ultra, I think it's the same as you
Warmest regards,
Christophe


After doing a new leveling, the 1st layer is flawless!
so do the leveling again
Warmest regards,

Christophe
Find
Reply


Messages In This Thread
RE: First layer sticks to FEP then nothing - by Christophe - 08-12-2023, 09:05 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)