Elegoo 3D Printers Forum › Troubleshooting › General Troubleshooting v
Model sink?

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Model sink?
CollinsA Offline
Junior Member
**
Posts: 12
Threads: 3
Joined: Sep 2019
Reputation: 0
#1
09-18-2019, 12:22 PM (This post was last modified: 09-18-2019, 01:10 PM by CollinsA.)
In the image what causes the model to sink or pull away from the supports? I get this every so often and cannot seem to figure out what would cause it. This seems to also be a cause of failed prints. Any insights would be great.

Thanks


Attached Files Thumbnail(s)
   
Find
Reply


Messages In This Thread
Model sink? - by CollinsA - 09-18-2019, 12:22 PM
RE: Model sink? - by admin - 09-19-2019, 02:01 AM
RE: Model sink? - by CollinsA - 09-19-2019, 07:50 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)