09-19-2019, 07:50 AM
admin Wrote:This is usually related to supports. Either not enough or the contact point isn't big enough. It's suggested to always use large supports too.Ok thank you
Model sink?
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
Model sink? - by CollinsA - 09-18-2019, 12:22 PM
RE: Model sink? - by admin - 09-19-2019, 02:01 AM
RE: Model sink? - by CollinsA - 09-19-2019, 07:50 AM
|