Elegoo 3D Printers Forum › Troubleshooting › General Troubleshooting v
NOISE IN THE AXIS Z

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
NOISE IN THE AXIS Z
jorge polo Offline
Junior Member
**
Posts: 4
Threads: 3
Joined: Feb 2020
Reputation: 0
#1
02-09-2020, 05:58 AM
Has anyone experienced noise when moving the z axis during printing? When I go up and down manually there is no noise.
Es un ruido similar a un salto, y solo ocurre en una sección del huso
Gracias por su apoyo
Find
Reply


Messages In This Thread
NOISE IN THE AXIS Z - by jorge polo - 02-09-2020, 05:58 AM
RE: NOISE IN THE AXIS Z - by fromFDMtoSLA - 02-09-2020, 06:15 AM
RE: NOISE IN THE AXIS Z - by jorge polo - 02-09-2020, 11:52 AM
RE: NOISE IN THE AXIS Z - by fromFDMtoSLA - 02-09-2020, 11:57 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)