Elegoo 3D Printers Forum › Elegoo Mars 3D Printer › Getting Started v
Print bottom not flat

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Print bottom not flat
fromFDMtoSLA Away
Member
***
Posts: 238
Threads: 10
Joined: Dec 2019
Reputation: 8
#2
04-26-2020, 04:12 AM (This post was last modified: 04-26-2020, 04:24 AM by fromFDMtoSLA.)
i had the same effect on the cube. after leveling with two pieces of paper and setting the stepper-rate in the config, it's gone
i find that out with this Thingi... modell: https://www.thingiverse.com/thing:1134677
you should also check the exposure times for the resin (bottom + layer)
Find
Reply


Messages In This Thread
Print bottom not flat - by Agan - 04-23-2020, 11:51 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-26-2020, 04:12 AM
RE: Print bottom not flat - by Icebox2 - 04-28-2020, 12:38 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-28-2020, 02:19 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 02:41 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 02:44 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 02:52 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 04:42 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 05:32 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 08:39 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 08:56 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 09:04 AM

Forum Jump:


Users browsing this thread: 3 Guest(s)