Elegoo 3D Printers Forum › Elegoo Mars 3D Printer › Getting Started v
Print bottom not flat

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Print bottom not flat
Agan Offline
Junior Member
**
Posts: 6
Threads: 1
Joined: Mar 2020
Reputation: 0
#9
04-29-2020, 05:32 AM
I see the idea. What do you mesure to replace for the extrusion ? The cube's normal size vs the result in one spot in particular ?

I'll have to wait before trying all of this on my printer, since the current temperature where I am has dropped to below 20°C, but I'll try the double paper sheet for leveling as soon as I can print again.
Find
Reply


Messages In This Thread
Print bottom not flat - by Agan - 04-23-2020, 11:51 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-26-2020, 04:12 AM
RE: Print bottom not flat - by Icebox2 - 04-28-2020, 12:38 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-28-2020, 02:19 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 02:41 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 02:44 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 02:52 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 04:42 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 05:32 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 08:39 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 08:56 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 09:04 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)