05-12-2020, 03:33 PM
Background - 2 week old Mars Pro with updated firmware provided by Elegoo via email
I turn on machine, loosen build plate screws, press "tools" button, enter the manual adjustment screen, Press "Home" button, re-tighten build plate screw, adjust build plate height until paper moves with slight pressure, go back one screen and press "Set z home"
I then go back to the Manual adjustment screen, press "Home" icon build plate goes back to its original position where paper is not movable until I adjust up 0.2mm.
Any help would be appreciated!
I turn on machine, loosen build plate screws, press "tools" button, enter the manual adjustment screen, Press "Home" button, re-tighten build plate screw, adjust build plate height until paper moves with slight pressure, go back one screen and press "Set z home"
I then go back to the Manual adjustment screen, press "Home" icon build plate goes back to its original position where paper is not movable until I adjust up 0.2mm.
Any help would be appreciated!