05-28-2020, 12:06 PM
It's more likely the model sticking to the FEP and creating a suction effect.
Is your model hollowed and "sealing" to the FEP? (Is it round, or are the layers printed in a completely "flat" effect?). If so, maybe add some drain holes on your print to ensure air and resin can escape and potentially cause less harm to the FEP layer.
Is your model hollowed and "sealing" to the FEP? (Is it round, or are the layers printed in a completely "flat" effect?). If so, maybe add some drain holes on your print to ensure air and resin can escape and potentially cause less harm to the FEP layer.