09-13-2020, 01:21 PM
(09-13-2020, 12:24 PM)TomWS Wrote: I found this post very useful, but I still have one question. Do you need to do this every time you repower the printer? In other words, is this a one time setup that is remembered after the printer is turned off? I have found that I can keep the printer running and do multiple prints with the same height calibration (including removing the bed and reinstalling), but I haven't tried printing without doing a height calibration after powering the printer on.
The "Z=0" setting is stored in non-volatile memory, there is no need to repeat the adjustment at each power-up.