Elegoo 3D Printers Forum › Elegoo Mars 3D Printer › Getting Started v
Mars Pro WILL NOT ZERO - HELP !

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Mars Pro WILL NOT ZERO - HELP !
cliffyk Offline
Senior Member
****
Posts: 558
Threads: 15
Joined: Mar 2020
Reputation: 22
#15
11-18-2020, 10:18 AM (This post was last modified: 11-18-2020, 10:19 AM by cliffyk.)
"tightening lightly the screws, stopping when I feel resistance" is not correct--they need to be "snugged up"--I.e. about 1/16th turn past when you feel resistance, same as tapered seat spark plugs...
-cliff knight-
[Image: 816-20120803-wide800.jpg]
paladinmicro.com
Find
Reply


Messages In This Thread
Mars Pro WILL NOT ZERO - HELP ! - by Frank Nova - 08-05-2020, 06:45 PM
RE: Mars Pro WILL NOT ZERO - HELP ! - by cliffyk - 08-06-2020, 06:47 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by szurlo - 08-16-2020, 07:32 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by cliffyk - 08-16-2020, 07:49 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by szurlo - 08-16-2020, 07:57 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by cliffyk - 08-16-2020, 09:57 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by Pete_R - 08-21-2020, 11:47 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by tbis1807 - 08-23-2020, 06:43 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by cliffyk - 08-21-2020, 09:17 PM
RE: Mars Pro WILL NOT ZERO - HELP ! - by k.i.a. - 11-15-2020, 03:01 PM
RE: Mars Pro WILL NOT ZERO - HELP ! - by cliffyk - 11-15-2020, 09:54 PM
RE: Mars Pro WILL NOT ZERO - HELP ! - by k.i.a. - 11-17-2020, 11:09 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by cliffyk - 11-17-2020, 11:37 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by k.i.a. - 11-17-2020, 02:34 PM
RE: Mars Pro WILL NOT ZERO - HELP ! - by cliffyk - 11-18-2020, 10:18 AM
RE: Mars Pro WILL NOT ZERO - HELP ! - by Jmac - 04-11-2021, 12:23 PM
RE: Mars Pro WILL NOT ZERO - HELP ! - by Photon - 03-10-2022, 07:57 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)