10-05-2020, 04:47 PM
I do not know if the printer supports the features, but to enable them in Chitubox you need to edit the ELEGOO_MARS.cfg file in the /resources/machine folder (may be called something else in Windows, I run Linux) and change the folowing values from "0" to "1":
change:
to:
This will make them visible in Chitubox, again however I do not know if the printer supports them. I have played with all a bit, if the printer does support the features their effect is very subtle at best...
change:
Code:
bAntiAliasing:0
bImageBlurVisible:0
bMinGreyLevelVisible:0
to:
Code:
bAntiAliasing:1
bImageBlurVisible:1
bMinGreyLevelVisible:1
This will make them visible in Chitubox, again however I do not know if the printer supports them. I have played with all a bit, if the printer does support the features their effect is very subtle at best...