11-02-2020, 09:16 AM
(This post was last modified: 11-02-2020, 09:18 AM by plate-of-shrimp.)
Same conclusion on my side.
Hmm, I'd say about 18 hours. The unit was commissioned only 3 days ago.
ELEGOO is sending me a replacement.
Thanks for looking.
In retrospect, I wonder if I did something to shorten the LCD lifetime; eg, I told Lychee to tell the printer something bad. Maximum layer time I have ever specified is 60s, for 5 burn-in layers.
Hmm, I'd say about 18 hours. The unit was commissioned only 3 days ago.
ELEGOO is sending me a replacement.
Thanks for looking.
In retrospect, I wonder if I did something to shorten the LCD lifetime; eg, I told Lychee to tell the printer something bad. Maximum layer time I have ever specified is 60s, for 5 burn-in layers.
ELEGOO Mars 2 Pro
ELEGOO Standard Resin (Gray)
ELEGOO Standard Resin (Gray)