resin drops on the uv cover after print complete
|
resin drops on the uv cover after print complete
|
03-06-2021, 03:32 PM
(03-06-2021, 01:56 PM)Sitopon Wrote: But this will keep the model in the bath of resin isn't it? AS I said I have not mucked about with any of this, however I suspect it would leve it at the top of the last lift--as in "after printing is completed"; the model is not in the goop "after" printing is complete. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
resin drops on the uv cover after print complete - by keithywhites - 11-29-2020, 08:43 AM
RE: resin drops on the uv cover after print complete - by Sitopon - 03-06-2021, 06:54 AM
RE: resin drops on the uv cover after print complete - by cliffyk - 03-06-2021, 12:07 PM
RE: resin drops on the uv cover after print complete - by Sitopon - 03-06-2021, 01:56 PM
RE: resin drops on the uv cover after print complete - by cliffyk - 03-06-2021, 03:32 PM
|
![[Image: 816-20120803-wide800.jpg]](http://www.paladinmicro.com/images/ForumPosts/816-20120803-wide800.jpg)