12-31-2020, 08:07 PM
Remove the vat and place it on a towel or a doubled-up paper towel--then use your fingernail to gently get under the "detritus" to lift and pry it off...
Elegoo 3D Printers Forum
›
Elegoo Mars 3D Printer
›
Maintenance & How-To
Mark on FEP Film After Initial Print
Mark on FEP Film After Initial Print
|
Mark on FEP Film After Initial Print
|
|
« Next Oldest | Next Newest »
|
![[Image: 816-20120803-wide800.jpg]](http://www.paladinmicro.com/images/ForumPosts/816-20120803-wide800.jpg)
| Messages In This Thread |
|
Mark on FEP Film After Initial Print - by basghetti - 12-30-2020, 07:32 PM
RE: Mark on FEP Film After Initial Print - by cliffyk - 12-31-2020, 08:07 PM
|
Users browsing this thread: 1 Guest(s)