01-09-2021, 08:06 AM
Try bumping the exposure to 8 to 9 s--here are the settings I use for Elegoo's gray standard resin:
![[Image: 20210109-GrayResinSettings.jpg]](http://www.paladinmicro.com/TestEquipment/ElegooMars/20210109-GrayResinSettings.jpg)
Elegoo 3D Printers Forum
›
Troubleshooting
›
Prints Sticking to the FEP Film
SOLVED MANY THANKS bottom of model not being printed correctly
SOLVED MANY THANKS bottom of model not being printed correctly
|
SOLVED MANY THANKS bottom of model not being printed correctly
|
|
« Next Oldest | Next Newest »
|
![[Image: 816-20120803-wide800.jpg]](http://www.paladinmicro.com/images/ForumPosts/816-20120803-wide800.jpg)
| Messages In This Thread |
|
SOLVED MANY THANKS bottom of model not being printed correctly - by GL550WL - 01-07-2021, 11:31 AM
RE: bottom of model not being printed correctly - by cliffyk - 01-08-2021, 10:43 AM
RE: bottom of model not being printed correctly - by GL550WL - 01-09-2021, 04:20 AM
RE: bottom of model not being printed correctly - by cliffyk - 01-09-2021, 08:06 AM
RE: bottom of model not being printed correctly - by GL550WL - 01-09-2021, 09:52 AM
RE:SOLVED MANY THANKS bottom of model not being printed correctly - by GL550WL - 01-09-2021, 01:59 PM
RE: SOLVED MANY THANKS bottom of model not being printed correctly - by cliffyk - 01-09-2021, 02:35 PM
|
Users browsing this thread: 2 Guest(s)