Elegoo 3D Printers Forum › Printing › ChiTuBox Slicer / Other Slicer Options v
unexpected membrane printed inside open bell

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
unexpected membrane printed inside open bell
cliffyk Offline
Senior Member
****
Posts: 558
Threads: 15
Joined: Mar 2020
Reputation: 22
#2
02-13-2021, 05:48 PM
You need to make some "vent" holes in the bell at the closed end to allow resin to drain between layers--else suction will trap it and light scatter from the curing lamp will partially cure the trapped resin:

[Image: Printing%20anomally.jpeg]
-cliff knight-
[Image: 816-20120803-wide800.jpg]
paladinmicro.com
Find
Reply


Messages In This Thread
RE: unexpected membrane printed inside open bell - by cliffyk - 02-13-2021, 05:48 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)