07-25-2021, 10:46 AM
If you export your current configuration and open the saved file in an editor, you should see a config line for "startGcode:"
change the line so it looks like this:
Then import the modified file into Chitubox.
Note that this is not the factory default, so use at your own risk.
See this document for known Chitu/Mars GCodes:
https://docs.google.com/document/d/14UBM...LOs3o/view#
change the line so it looks like this:
Code:
startGcode: "M8030 T-2"
Then import the modified file into Chitubox.
Note that this is not the factory default, so use at your own risk.
See this document for known Chitu/Mars GCodes:
https://docs.google.com/document/d/14UBM...LOs3o/view#