07-18-2019, 02:29 PM
BE SURE that when you open Chituboxthat you check under setting that you have the Elegoo Mars set as the printer. If you don't everything will come out skewed and wonky jawed.
Elegoo 3D Printers Forum
›
Elegoo Mars 3D Printer
›
Getting Started
Check Printer setting on Chitubox startup!
Check Printer setting on Chitubox startup!
|
Check Printer setting on Chitubox startup!
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Check Printer setting on Chitubox startup! - by JoePeacock - 07-18-2019, 02:29 PM
RE: Check Printer setting on Chitubox startup! - by CollinsA - 09-06-2019, 06:50 AM
RE: Check Printer setting on Chitubox startup! - by MarkE - 09-07-2019, 06:44 AM
|
Users browsing this thread: 1 Guest(s)