Posts: 238
Threads: 10
Joined: Dec 2019
Reputation:
8
what is the layer-height?
Posts: 7
Threads: 2
Joined: Feb 2020
Reputation:
0
02-09-2020, 11:19 AM
(This post was last modified: 02-09-2020, 11:22 AM by FrozT.)
0.050 which I assume is the default set when selecting Elegoo Mars as my printer. All of my settings are essentially default.
Do you think I need to increase the exposure time due to the large coverage area?
Posts: 238
Threads: 10
Joined: Dec 2019
Reputation:
8
i ask, because the sides of the model look like layers with bigger heigt - never seen this before (looks like FDM-printed).
increase the exposure time may be an option, but i'm not shure, what the main problem is
Posts: 238
Threads: 10
Joined: Dec 2019
Reputation:
8
02-09-2020, 10:58 PM
(This post was last modified: 02-09-2020, 10:59 PM by fromFDMtoSLA.)
very strange, because the "wobble" is only on some surfaces - some surfaces look OK, supports without "wobbling", the "Rook" is nearly perfect -.
Can/will you upload the *.stl of your model, to have a look on it?
by the way: which slicer-version?
Posts: 31
Threads: 0
Joined: Oct 2019
Reputation:
2
... could be, the surface area in contact is so big, it will distort the part while ripping off ...
Viktor