05-31-2021, 06:35 AM
Hi,
I got my Saturn a month ago, did the leveling and printed a lot since.
a week ago i punctured my FEP ( my fault ), replaced the FEP, releveled, and printed fine till yesterday.
yesterday I started a print and left it alone, about 15min later i noticed nothing was on the plate, stopped the print cleaned the vat.
I releveled and started a new print but watched the plate go into the resin, but instead of staying down it lifted about 5-10mm and printed on the FEP.
Then i cleand everything again and releveled, but the same keeps happening.
It always goes down to zero but then it lifts
I hope someone can help me
Thanks in advance
I got my Saturn a month ago, did the leveling and printed a lot since.
a week ago i punctured my FEP ( my fault ), replaced the FEP, releveled, and printed fine till yesterday.
yesterday I started a print and left it alone, about 15min later i noticed nothing was on the plate, stopped the print cleaned the vat.
I releveled and started a new print but watched the plate go into the resin, but instead of staying down it lifted about 5-10mm and printed on the FEP.
Then i cleand everything again and releveled, but the same keeps happening.
It always goes down to zero but then it lifts
I hope someone can help me
Thanks in advance