12-30-2021, 08:09 PM
(This post was last modified: 12-30-2021, 11:03 PM by BryadenNewbie.)
Hi fellow Elegoo users! I bought the Saturn for my son for Christmas and we got started today. We are new to this but excited to work!
We set everything up and I believe we did everything right. It was going through the motions to print the “test rook” and the screen said 16% when we left the room. I came back about 4 hours later and for some reason it didn’t print anything?? The resin is still a liquid and now I decided to push print to try again and when the base plate reaches the “bottom” (below the resin) it makes a grinding noise. Any suggestions?
Please help.
Thank you!
Ryan
Edit - Once I cleaned it I found it printed 2 small quarter sized pieces but didn’t get any larger than quarter size.
We set everything up and I believe we did everything right. It was going through the motions to print the “test rook” and the screen said 16% when we left the room. I came back about 4 hours later and for some reason it didn’t print anything?? The resin is still a liquid and now I decided to push print to try again and when the base plate reaches the “bottom” (below the resin) it makes a grinding noise. Any suggestions?
Please help.
Thank you!
Ryan
Edit - Once I cleaned it I found it printed 2 small quarter sized pieces but didn’t get any larger than quarter size.