Hi all, I’m new to 3d printing… got the elegoo mars 2 pro for Christmas and only just done the rook test print.
Everything went smoothly and got two rooks but… there seems to be a little flaking and not sure what would have caused it. No other issues visible.
I used the test as is (probably the issue) so whatever settings it had baked in. The resin I used was the grey elegoo water washable rapid resin.
I’ve attached a picture and look forward to hearing from you all.
Many thanks (happy new year)
Muzzy
Everything went smoothly and got two rooks but… there seems to be a little flaking and not sure what would have caused it. No other issues visible.
I used the test as is (probably the issue) so whatever settings it had baked in. The resin I used was the grey elegoo water washable rapid resin.
I’ve attached a picture and look forward to hearing from you all.
Many thanks (happy new year)
Muzzy