03-06-2022, 03:48 PM
The platen is not properly aligned (so-called "leveling"¹)--do it again...
¹ - The process of aligning the platen with the LCD shutter is often and incorrectly called "leveling", though it is NOT, no reference tool (I.e. a "level") is used, nor is anything adjusted to be perpendicular to the force of gravity. It is just an "alignment" to assure the surface of platen is parallel to the surface of the LCD screen.
"Leveling" is a term carried over from FDM printing where the build plate is leveled.
¹ - The process of aligning the platen with the LCD shutter is often and incorrectly called "leveling", though it is NOT, no reference tool (I.e. a "level") is used, nor is anything adjusted to be perpendicular to the force of gravity. It is just an "alignment" to assure the surface of platen is parallel to the surface of the LCD screen.
"Leveling" is a term carried over from FDM printing where the build plate is leveled.
![[Image: 816-20120803-wide800.jpg]](http://www.paladinmicro.com/images/ForumPosts/816-20120803-wide800.jpg)