03-05-2022, 08:27 AM
Hello, I have a mars (1) with which I have been able to see plate v2 type C.
I would like to change the screen for a monochrome one, in order to reduce printing times (in this machine I have them at a height of 0.05mm 10 seconds).
I have seen the following screen:
fhd mono lcd
I think it is compatible with my board, but I think I have to change the firmware...
my questions are:
If I change the firmware and then I want to go back to my old screen, what firmware should I put...
and if there is a place to compare miniatures printed with the two screens... since the mono one I think has less resolution... and I usually use it to print wargame miniatures like warhammer...
Thank you.
I would like to change the screen for a monochrome one, in order to reduce printing times (in this machine I have them at a height of 0.05mm 10 seconds).
I have seen the following screen:
fhd mono lcd
I think it is compatible with my board, but I think I have to change the firmware...
my questions are:
If I change the firmware and then I want to go back to my old screen, what firmware should I put...
and if there is a place to compare miniatures printed with the two screens... since the mono one I think has less resolution... and I usually use it to print wargame miniatures like warhammer...
Thank you.