03-24-2023, 10:20 AM
Hello everyone,
I use Chitubox which I find quite simple for supports and slicing.I updated Chitubox (1.9) recently (I don't know if my problem is related)I do everything as usual to prepare the impression of a small simple object (a gas tank 3cm long, basically a cylinder with few details)I tilt the object, I lift it 5mm from the board, I put supports everywhere (thin)I slice, I save on key and I print....3 attempts: 3 failures: it only prints the supports and not the object.this is the first time this has happened to me.do you have an idea? Thank you in advance for your help. Philip
I use Chitubox which I find quite simple for supports and slicing.I updated Chitubox (1.9) recently (I don't know if my problem is related)I do everything as usual to prepare the impression of a small simple object (a gas tank 3cm long, basically a cylinder with few details)I tilt the object, I lift it 5mm from the board, I put supports everywhere (thin)I slice, I save on key and I print....3 attempts: 3 failures: it only prints the supports and not the object.this is the first time this has happened to me.do you have an idea? Thank you in advance for your help. Philip