I recently changed my print area LCD (monochrome 2K) and applied a screen protector (I had FEP fail and get resin on the factory screen, lesson learned). First print went off without a hitch. Everything was fine.
Second through fifth attempts at printing however...
![[Image: SXchZFRm.jpg]](https://i.imgur.com/SXchZFRm.jpg)
Off to one side with everything. I run a tank clean to get where everything started printing okay for the first few layers.
If anyone has some insight, I'd appreciate it. I double checked, and my firmware is up to date to the latest on the Elegoo supports downloads for my printer.
Second through fifth attempts at printing however...
Off to one side with everything. I run a tank clean to get where everything started printing okay for the first few layers.
If anyone has some insight, I'd appreciate it. I double checked, and my firmware is up to date to the latest on the Elegoo supports downloads for my printer.