10-15-2019, 06:45 AM
Has anyone tried upgrading the UV-LED yet, or has anyone taken a closer look at the stock LED as in what kind of dimensions it has?
I would love to upgrade the LED setup since it could reduce curing time per layer by a few seconds each.
I have yet to take my Mars apart but any insight on what kind of LED or Mosfet is powering the LED would be greatly appreciated before i start tinkering on my own!
I have already found an LED that might fit the bill for a 50W or even 100W upgrade on aliexpress since those LED modules are likely standardized:
https://www.aliexpress.com/item/33046362...4c4dVeFmli
Since all the modules from 20W upwards have the same supply voltage a simple swap out might even be possible if the on board mosfet is up to the task!
What do you guys think?
I would love to upgrade the LED setup since it could reduce curing time per layer by a few seconds each.
I have yet to take my Mars apart but any insight on what kind of LED or Mosfet is powering the LED would be greatly appreciated before i start tinkering on my own!
I have already found an LED that might fit the bill for a 50W or even 100W upgrade on aliexpress since those LED modules are likely standardized:
https://www.aliexpress.com/item/33046362...4c4dVeFmli
Since all the modules from 20W upwards have the same supply voltage a simple swap out might even be possible if the on board mosfet is up to the task!
What do you guys think?