12-29-2019, 11:10 PM
New to the forum and fairly new to the printing 3 weeks. I notice that from time to time I am getting some white spots from my prints. I spray my parts with 91% Alcohol,I clean with mean green 50% and distilled water. 10 min in my ultrasonic. Rinse with water several times to remove any soap. Then put them in a 99% percent alcohol for a bout 2 - min. air dry and put in my uv light for about 1/2 hr. I see the spots and they are pretty much in pitted areas of the design or along the border. The rest looks good.
Thanks for anything that points to the right direction.
Thanks for anything that points to the right direction.