07-18-2019, 08:36 AM
These are the steps i use to remove Failed prints from my vat so far they seem to come off really easy
1.empty the vat of all resin
2 Apply isopropyl alcohol (I use 99.8% but 91% should work) to the vat
3 very gently press the opposite side of fep sheet while lifting the print with your other hand it should peel away with out damaging the fep sheet
4 wipe vat with a soft paper towel with alcohol
5 set it out to dry
I know every one may not do it this way but this is how i have been removing mine and haven't had a problem or any damage to my fep.
1.empty the vat of all resin
2 Apply isopropyl alcohol (I use 99.8% but 91% should work) to the vat
3 very gently press the opposite side of fep sheet while lifting the print with your other hand it should peel away with out damaging the fep sheet
4 wipe vat with a soft paper towel with alcohol
5 set it out to dry
I know every one may not do it this way but this is how i have been removing mine and haven't had a problem or any damage to my fep.