04-26-2020, 04:12 AM
(This post was last modified: 04-26-2020, 04:24 AM by fromFDMtoSLA.)
i had the same effect on the cube. after leveling with two pieces of paper and setting the stepper-rate in the config, it's gone
i find that out with this Thingi... modell: https://www.thingiverse.com/thing:1134677
you should also check the exposure times for the resin (bottom + layer)
i find that out with this Thingi... modell: https://www.thingiverse.com/thing:1134677
you should also check the exposure times for the resin (bottom + layer)