Elegoo 3D Printers Forum › Elegoo Mars 3D Printer › Getting Started v
Print bottom not flat

 
Thread Rating:
  • 0 Vote(s) - 0 Average
Thread Modes
Print bottom not flat
fromFDMtoSLA Away
Member
***
Posts: 238
Threads: 10
Joined: Dec 2019
Reputation: 8
#8
04-29-2020, 04:42 AM (This post was last modified: 04-29-2020, 04:47 AM by fromFDMtoSLA.)
the text is direct out of the config - i don't know, why they are talking about the "lead"
i calculated the M8010 S0.xxx in the same way, i did it for my FDM-printers
- like this for example: http://3daddict.com/3d-printer-extruder-...ion-steps/,
have a look at the "Extruder Calibration Calculator"- section

example:


Attached Files Thumbnail(s)
   
Find
Reply


Messages In This Thread
Print bottom not flat - by Agan - 04-23-2020, 11:51 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-26-2020, 04:12 AM
RE: Print bottom not flat - by Icebox2 - 04-28-2020, 12:38 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-28-2020, 02:19 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 02:41 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 02:44 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 02:52 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 04:42 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 05:32 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 08:39 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 08:56 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 09:04 AM

Forum Jump:


Users browsing this thread: 4 Guest(s)