|
Print bottom not flat
|
04-29-2020, 08:39 AM
Just had the chance to try, as temperature rose today. However, in leveling with two sheets (but without changing stepper rate) I got an even worse print, with sides full taken off the build plate on the right, and a print sticking to the FEP at the end.
I'll post the results later to show, when I have the chance to upload the images. |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Print bottom not flat - by Agan - 04-23-2020, 11:51 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-26-2020, 04:12 AM
RE: Print bottom not flat - by Icebox2 - 04-28-2020, 12:38 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-28-2020, 02:19 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 02:41 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 02:44 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 02:52 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 04:42 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 05:32 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 08:39 AM
RE: Print bottom not flat - by fromFDMtoSLA - 04-29-2020, 08:56 AM
RE: Print bottom not flat - by Agan - 04-29-2020, 09:04 AM
|
