07-10-2020, 09:14 PM
(07-10-2020, 03:32 PM)cliffyk Wrote: I sent an email to Elegoo support asking specifically about the [Z=0] button intent and function--that was at 9:32 a.m. EST; i will report if I hear anything back...
Did you hear anything back? Just got mine, leveled it according to the one sheet of paper and nothing but buzzing and nothing works. Screen works on the test, nothing prints. Seems this firmware is so buggy that I have to go at least 5mm to make it move the paper. Pretty frustrating as I have had 3 FDM printers and deal with leveling just fine with those.