07-21-2020, 04:12 AM
(This post was last modified: 07-21-2020, 04:13 AM by ResinJunkie.)
Greetings.
I've searched the forum and haven't found an answer. Either the troubleshooting dies out and no one responds or resolves it or the problem isn't exactly what I am experiencing.
I am not a new printer I have a Creality LD002, Creality Ender Pro, and have had both since January. Just got a Elegoo Mars yesterday.
Spent some time reading the user guide. Watching a few videos to make sure I understand setup and calibration.
Printer calibrates fine.
Test print of the rook went perfect.
Printer fails to print anything else.
Each time (3x now) there is cured resin on the vat screen. The "base" of my print to be exact. I clean everything, dry it, (I clean and dry every time I print any how), recalibrate it. I have run the test print twice so I have 4 rooks I don't know what do with
Everything goes as it should yet my print doesn't go through. What else is the issue.
I've searched the forum and haven't found an answer. Either the troubleshooting dies out and no one responds or resolves it or the problem isn't exactly what I am experiencing.
I am not a new printer I have a Creality LD002, Creality Ender Pro, and have had both since January. Just got a Elegoo Mars yesterday.
Spent some time reading the user guide. Watching a few videos to make sure I understand setup and calibration.
Printer calibrates fine.
Test print of the rook went perfect.
Printer fails to print anything else.
Each time (3x now) there is cured resin on the vat screen. The "base" of my print to be exact. I clean everything, dry it, (I clean and dry every time I print any how), recalibrate it. I have run the test print twice so I have 4 rooks I don't know what do with
Everything goes as it should yet my print doesn't go through. What else is the issue.