07-30-2020, 03:43 AM
I'm having a problem with my new Elegoo Mars Pro which has occurred after just a couple of days
When the build plate reaches the bottom of its travel to start a print, the motor does not stop and is trying to push the build plate further down. It's making a groaning noise, so of course I hit the stop button when to happens
I have tried re-setting the z=0 several times (including after leaving machine turned off for a few hours), but the machine does not seem to accept the new home/0 position - the problem persists.
Any suggestions?
When the build plate reaches the bottom of its travel to start a print, the motor does not stop and is trying to push the build plate further down. It's making a groaning noise, so of course I hit the stop button when to happens
I have tried re-setting the z=0 several times (including after leaving machine turned off for a few hours), but the machine does not seem to accept the new home/0 position - the problem persists.
Any suggestions?