09-06-2020, 12:36 PM
Hi,
I just got an Elegoo Mars 2 Pro as a first printer and I've had some issues printing anything else than the Rooks.
I've tried printing a figurine but I get a lot of support fails. The figurine comes pre-supported and no one seems to complain so I'm trying to troubleshoot my setup first.
I'm using White Elegoo Water washable resin with the default settings in Chitubox.
To make sure that the model wasn't the issue, I've tried printing something less complex (https://www.myminifactory.com/object/3d-...ner-120829).
And this was the result (along with the settings):
https://imgur.com/a/OUOgtRI
The model came out good but I noticed several (not all) supports failures along with weird bumps on the underside of the base. Maybe this could be related to my previous issues.
Any ideas what could be the problem?
Should I raise the exposure time to allow for the supports to stick better? Could it be that my FEP is too loose (I loosened it a little bit while troubleshooting my first figurine)?
Thanks!
I just got an Elegoo Mars 2 Pro as a first printer and I've had some issues printing anything else than the Rooks.
I've tried printing a figurine but I get a lot of support fails. The figurine comes pre-supported and no one seems to complain so I'm trying to troubleshoot my setup first.
I'm using White Elegoo Water washable resin with the default settings in Chitubox.
To make sure that the model wasn't the issue, I've tried printing something less complex (https://www.myminifactory.com/object/3d-...ner-120829).
And this was the result (along with the settings):
https://imgur.com/a/OUOgtRI
The model came out good but I noticed several (not all) supports failures along with weird bumps on the underside of the base. Maybe this could be related to my previous issues.
Any ideas what could be the problem?
Should I raise the exposure time to allow for the supports to stick better? Could it be that my FEP is too loose (I loosened it a little bit while troubleshooting my first figurine)?
Thanks!