09-08-2020, 06:22 PM
I've been trying for 48hrs to successully print baby yoda ( https://www.myminifactory.com/object/3d-...oda-105405 ) and an ocarina ( https://www.thingiverse.com/thing:2798487 ) on the elegoo mars 2 pro.
The default supports always fail at the jonction of the support and the model (tried 75% support, increasing contact surface to 1mm, etc without success),. The model detaches itself from the supports leadin to a print failure.
The only thing I've found is to increase the exposure time to 8 seconds, which defeats the purpose of having a mono lcd screen.
Any way to throubleshoot this ?
Usefull settings for ChiTuBox ?
The default supports always fail at the jonction of the support and the model (tried 75% support, increasing contact surface to 1mm, etc without success),. The model detaches itself from the supports leadin to a print failure.
The only thing I've found is to increase the exposure time to 8 seconds, which defeats the purpose of having a mono lcd screen.
Any way to throubleshoot this ?
Usefull settings for ChiTuBox ?