09-22-2020, 06:58 AM
Hi all, my first post here. Recently got the Mars and successfully printed both rooks first time. After about 5 failed custom prints I finally got some that completed!
There were some blemishes however that I would like to fix before I try printing them again.
On one of my models, on a corner, there seems to have been layers of resin peeled away. Is this delamination? If so, how can this be prevented? If I printed the model again without changing anything would I likely get the same result?
On another model, on the first few layers that were printed above the supports, there seems to be a much thicker layer of resin built up. It's not really something that looks like it can be fixed with sanding etc, so was wondering what this might be and a possible solution?
Thanks for your time and look forward to seeing if this can be resolved
There were some blemishes however that I would like to fix before I try printing them again.
On one of my models, on a corner, there seems to have been layers of resin peeled away. Is this delamination? If so, how can this be prevented? If I printed the model again without changing anything would I likely get the same result?
On another model, on the first few layers that were printed above the supports, there seems to be a much thicker layer of resin built up. It's not really something that looks like it can be fixed with sanding etc, so was wondering what this might be and a possible solution?
Thanks for your time and look forward to seeing if this can be resolved