09-22-2020, 09:27 AM
(This post was last modified: 09-22-2020, 09:38 AM by vachonworks.)
Hi there, this may have been covered before
But I'm getting a warped diagonal shift in my prints
These sometimes happen 10mm into a print or higher
I've had this problem on all prints
Sometimes it's a shift horizontal or staggered shift
I have ordered now film too
No amount of angle change helps
My suspicion is a faulty z axis screw or moving screen?
im going to take the thing apart tongith and investigate
But I'm getting a warped diagonal shift in my prints
These sometimes happen 10mm into a print or higher
I've had this problem on all prints
Sometimes it's a shift horizontal or staggered shift
I have ordered now film too
No amount of angle change helps
My suspicion is a faulty z axis screw or moving screen?
im going to take the thing apart tongith and investigate