09-24-2020, 06:14 AM
(This post was last modified: 09-24-2020, 06:15 AM by Dirty Kibbles.)
I am new to the resin printing and I just got an Elegoo Mars 2 Pro. I am trying to print a Settlers of Catan piece and running into the same fail (three times now). If I compared the failure to my filament printer, it looks like my build plate is too hot (obviously not what is going on here). I am using the Elegoo Rapid Resin (Grey). I am printing directly on the build plate and the slicer setting are attached below (The other settings were left unchanged). I have re-leveled the build plate and messed with the lift distance settings. I am not sure where to go next. Please help an newbie out!