10-04-2020, 07:59 AM
Hello,
So I have recently bought a Elegoo Mars Pro, I have has some successful prints but a lot of failures. And I have tried almost everything to fix the problems (I think). I am using the Elegoo ABS-like Gray Resin, I will share some pictures of my settings below. I have tuned my settings many times, but the failures are so random that I don't really know if it is my settings or something else causing the failures. Things I have tried the following.
Also a weird thing is that I tend to have successful prints when it's dark outside/inside, during the day they all fail. I have my Printer in the kitchen and there is a lot of sunlight coming in during the day, could this be the main problem? Also I must say that it's typically around 20 to 21 degrees inside instead of the recommended 25 degrees... Maybe this can also be the problem but that means i should always have failures and not is more like 80% failure 20% success.
I hope one of you has the answer to my problem or things I can still try.
So I have recently bought a Elegoo Mars Pro, I have has some successful prints but a lot of failures. And I have tried almost everything to fix the problems (I think). I am using the Elegoo ABS-like Gray Resin, I will share some pictures of my settings below. I have tuned my settings many times, but the failures are so random that I don't really know if it is my settings or something else causing the failures. Things I have tried the following.
- Leveling the Build Plate
- Using ptfe lubricant
- Using masking tape underneath the FEP film to (maybe) fix vacuum effect.
- Lowering my lift speed
- Using extra supports (even on pre-supported prints)
Also a weird thing is that I tend to have successful prints when it's dark outside/inside, during the day they all fail. I have my Printer in the kitchen and there is a lot of sunlight coming in during the day, could this be the main problem? Also I must say that it's typically around 20 to 21 degrees inside instead of the recommended 25 degrees... Maybe this can also be the problem but that means i should always have failures and not is more like 80% failure 20% success.
I hope one of you has the answer to my problem or things I can still try.