OK, the destructive test:
I clamped it rather firmly into my small bench vise ("upside down" at the third step):
Then whacked it (one good sharp blow) with a 16 oz. ball peen:
It held up pretty good for a 3-D printed thingy (you can see the indentations from the vise jaw):
Again, a 50/50mix of Tenacious and some cheap gray crap.
Seems like good mix, now I need to print some sort of real component...
I clamped it rather firmly into my small bench vise ("upside down" at the third step):
Then whacked it (one good sharp blow) with a 16 oz. ball peen:
It held up pretty good for a 3-D printed thingy (you can see the indentations from the vise jaw):
Again, a 50/50mix of Tenacious and some cheap gray crap.
Seems like good mix, now I need to print some sort of real component...