Elegoo's FAQ has an item re: Z-axis problems (see here); "loose cable connector" is not mentioned--but it should be as it seems somewhat commonplace with many of the newer production units; as are other assembly issues. Perhaps they are pushing the final assembly lines too hard...
Elegoo 3D Printers Forum
›
Troubleshooting
›
General Troubleshooting
Mars 2 Pro - unable to level or set Z=0, loud humm
Mars 2 Pro - unable to level or set Z=0, loud humm
|
Mars 2 Pro - unable to level or set Z=0, loud humm
|
|
« Next Oldest | Next Newest »
|
![[Image: 816-20120803-wide800.jpg]](http://www.paladinmicro.com/images/ForumPosts/816-20120803-wide800.jpg)
| Messages In This Thread |
|
Mars 2 Pro - unable to level or set Z=0, loud humm - by pouncingdragon - 01-15-2021, 09:28 AM
RE: Mars 2 Pro - unable to level or set Z=0, loud humm - by pouncingdragon - 01-15-2021, 03:47 PM
RE: Mars 2 Pro - unable to level or set Z=0, loud humm - by cliffyk - 01-15-2021, 05:36 PM
RE: Mars 2 Pro - unable to level or set Z=0, loud humm - by ClockworkAether - 07-21-2021, 01:05 PM
RE: Mars 2 Pro - unable to level or set Z=0, loud humm - by dfjones - 08-29-2021, 04:05 AM
|
Users browsing this thread: 2 Guest(s)