02-19-2021, 11:34 AM
Hello,
I just received my Saturn printer. I levelled the bed using the cardboard sheet as recommended. I ran the rook test prints they both turned out good.
The issue I have is I am hearing a knocking noise every time the bed moves down to its layer position. This noise only occurs on the first few layers then goes away. Any thoughts on this would be appreciated. I did check all the screws on the Z axis to make sure they were all tight... they were.
Thanks,
I just received my Saturn printer. I levelled the bed using the cardboard sheet as recommended. I ran the rook test prints they both turned out good.
The issue I have is I am hearing a knocking noise every time the bed moves down to its layer position. This noise only occurs on the first few layers then goes away. Any thoughts on this would be appreciated. I did check all the screws on the Z axis to make sure they were all tight... they were.
Thanks,