03-25-2021, 03:42 PM
I've attempted about 5 or 6 prints so far but I've only had 2 that completed successfully. One was the rook test file. The other was a benchy. Both of these had no supports and were printed directly on the build plate.
Every other time I've tried to print a model that has supports, they all fail. The supports do not even get printed, just the raft. Is this issues with the slicer (I'm using lychee) or the printer itself? I don't think the bed leveling is an issue since I've printed 2 successful times on it and it has not been adjusted since.
Thanks
Every other time I've tried to print a model that has supports, they all fail. The supports do not even get printed, just the raft. Is this issues with the slicer (I'm using lychee) or the printer itself? I don't think the bed leveling is an issue since I've printed 2 successful times on it and it has not been adjusted since.
Thanks